Note : NetUSB is only available in Windows 2000/XP/2003. Windows
98/ME is not supported.
I. NetUSB Printing
After the driver is installed , you can see a newly created printer in
the Control Panel’s “Printers and Faxes”. Follow the steps below to
do a NetUSB printing.
A. In the Control Center, click the MFP server that has the desired
printer (or MFP) attached.
B. Click the desired printer (or MFP).
C. Click the “Auto Connect Printer” button and choose “Set
Auto-Connect Printer”. The following figure will appear.
9
To Next Page
Loading...
