5 SysLocation: enter some letters for variable of SysLocation that represents
the location of system.
5 EnableAuthenTrap: enter 1 or 2 for the variable of EnableAuthenTrap that
represents to enable (1) or disable (2) to send Trap packets receiving the
wrong Community name.
SNMP V3
5 Enable SNMP V3: select or clear Enable SnmpV3 support
5 User Security name: set user security name of SNMP v3
5 Auth Password: set authentication password of SNMP v3.
5 Privacy Password: set privacy password of SNMP v3.
Email: If you want to receive some alerting mail from the Server, you have to
enable SMTP Protocol, and set Email configuration. You can set new SMTP port
number (default: 25).
Set Email Configuration
5 SMTP Protocol: select or clear Enable SMTP support
5 SMTP Server Name: enter your SMTP server’s Server Name or IP
address.
5 SMTP Port Number: set new SMTP server’s TCP port number (default:
25).
5 Subject: enter the subject of the e-mail.
5 From Address: enter the sender’s e-mail address.
5 To Address: enter an e-mail address to send that mail to a person.
69
To Next Page
Loading...
