14
Step2: Select “Network” to make network settings based on your network
environment. There are three network connection types: Static IP, PPPOE, and
DHCP.
Note: This camera doesn’t support POE router or hub.
For Static IP:
a) Enter the information of “Server IP”, “Gateway” and “NetMask” obtained from your ISP
(Internet Service Provider).
b) Enter the port number. The valid number ranges from 1 to 9999. The default value is 80.
Typically, the TCP port used by HTTP is 80. However in some cases, it is better to change
this port number for added flexibility or security.
c) Click “Apply”, and click “OK” to exit the setting page.
For PPPOE:
a) Go to “Network” “DDNS”, and select “default” in the “System Name” drop-down list.
b) In “Hostname”, keep the default value, i.e. the MAC address of this camera, or change the
name to a meaningful one. It’s easier to memorize.
c) Note down the whole address of the camera, for example,
MAC000E53114389.ddns.dvrtw.com.tw.
Note: You can also create a DDNS account from a website which provides free
DDNS service. For details, please refer to “APPENDIX CREATING AN
ACCOUNT FOR DDNS SERVICE” at page 17.
d) Go to “Network” and select “PPPOE”. Then, enter the user name and password obtained
from your ISP.
To Next Page
Loading...
Need help?
General
