Why does my Digitus DN-170063 alarm beep continuously when AC supply is normal?
The alarm may beep continuously because the UPS is overloaded. Verify that the load matches the UPS capability specified in the specs.
What to do if my Digitus DN-170063 backup time is shortened during a power failure?
If the backup time of your Digitus UPS is shortened during a power failure, it could be due to several reasons: * The UPS might be overloaded; try removing some non-critical load. * The battery voltage may be too low; charge the battery for 6-8 hours. * The battery may be defective due to a high-temperature operating environment or improper operation; in this case, replace it with the same type of battery.
What to do if mains are normal but battery mode indicator lights on Digitus UPS?
If the mains are normal but the battery mode indicator light is on (for LCD models) or the yellow LED is flashing (for LED models) on your Digitus UPS, the power cord might be loose. Reconnect the power cord properly.
How to fix no LCD/LED display on Digitus UPS?
If there is no LCD lighting (for LCD model) or no LED display (for LED model) on the front panel of your Digitus UPS, it could be due to: 1. A weak battery: Charge the battery for up to 8 hours. 2. A defective battery: Replace it with the same type of battery. 3. The power switch is not pressed: Press the power switch again.
General| Output Power Capacity | 600 VA / 360 W |
|---|---|
| Nominal Input Voltage | 230 V |
| Output Voltage | 230 V |
| Protection | Overload, Discharge, and Overcharge Protection |
| Waveform Type | Simulated Sine Wave |
| Output Frequency | 50/60 Hz |
| Battery Type | Sealed Lead Acid |
| Outlets | 4 x IEC C13 |
| Communication Port | USB |
| Input Voltage Range | 162-290 VAC |
| Transfer Time | 2-6 ms typical |
| Typical Recharge Time | 6 hours to 90% capacity |
To Next Page
