Page 4
4. To install the card, carefully align the card’s bus connector
with the selected PCIe slot on the motherboard. Push the
board down firmly.
5. Connect the system power source to the board’s power
connector.
6. Replace the slot bracket’s holding screw to secure the card.
7. Replace the computer cover and reconnect the power cord.
Driver Installation
Please make sure the board is installed before proceeding with
driver installation.
Important: If your system doesn’t boot to Windows properly with
our card installed, check with your system’s manufacturer for the
latest system firmware update.
For Windows® 7 / Vista / Server 2003 SP1 or above /
XP / 2000
Note: Server 2003 Server Pack 1 or above is required to
install the FireWire 800 Card 3 Ports successfully.
To Next Page
Loading...
Need help?
General
