Need help?Do you have a question about the Dimatix DMP-2800 Series and is the answer not in the manual?
General| Drop Velocity | 10 m/s |
|---|---|
| Interface | USB 2.0 |
| Nozzle Count | 16 |
| Drop Volume | 1 pL, 10 pL |
| Substrate Thickness | Up to 25 mm (1 inch) |
| Printhead Height | Adjustable |
| Registration accuracy | ± 25 μm |
| Ink Compatibility | Water-based, solvent-based, UV-curable |
| Operating temperature | 15°C to 30°C (59°F to 86°F) |
| Operating System Compatibility | Windows 7 |
| Power Requirements | 100-240 VAC, 50/60 Hz |
| Fluid viscosity | 8 - 20 cP |
Step-by-step guide for installing the Dimatix Model Fluid Cartridge.
Selecting print patterns and configuring print settings before jetting.
Adjusting cartridge parameters and waveform settings for jetting.
Screen for editing electrical signals that trigger drop ejection.
Selecting, creating, and printing custom patterns on substrates.
Using the Drop Watcher for viewing jetting nozzles and drop formation.
To Next Page