Dimension One Spas 1998 - Page 25

23
1998 Owner’s Manual
“FL”- LOW FLOW
When “FL” is displayed, check the following:
1) Check the water level to see if it is too low. If the water level is too
low, fill the spa to one to two inches above the bottom of the tile line.
2) A flow switch has malfunctioned. The spa will operate but the heater
will not activate. Contact your local Authorized Dimension One Spas
Dealer, or authorized service center.
“SN” - OPEN SENSOR
When “SN” is displayed, check the following:
The high limit sensor or water temperature sensor is non-functional.
Contact your local Authorized Dimension One Spas dealer, or authorized
service center.