Drainage
While the water tank is full, the compressor will stop for self-protection and the water
full indicator light will turn red.
To move the water tank, pull it out squarely from the unit.
After empting the water tank, place the water tank carefully back into its location into
indicator will stay red and the product will not operate.
CONTINUOUS DRAINAGE
require more frequent emptying. In this situation, it may be more convenient to set the
2. Connect a water drain tube of inner
diameter 11 mm to the drain spout
connection outlet at the top of the
tank location area.
* Please note, the water tube is not supplied
with the unit.
and that water will always drain away
point/open end of the tube must be
at a lower height than the drain outlet
Note! In very cold weather conditions,
precautions should be taken to prevent the
water tube from freezing.
Spout connection
for continuous
drainage
Water drain tube
with 11mm internal
diameter
Always unplug the unit from the mains before carrying out any maintenance or cleaning
of the unit.
CLEANING THE BODY
Use a soft damp cloth to wipe the unit clean.
other cleansing solutions. These all could possibly damage the enclosure.
CLEANING THE FILTER
and replaced if necessary.
WASHING THE PLASTIC DUST FILTER
•
and set it aside carefully.
•
•
•
STORAGE
•
• Completely empty the water tank and clean it thoroughly and wipe it dry.
•
Cover the unit and store it upright in a location where it will not receive direct sunlight.
Maintenance
Anti-Dust
Filter
Active Carbon
Filter
Air Inlet
13
12
To Next Page
Loading...
Need help?
General
