www.dimplex.com2
The Manufacturer warrants the linear convector and components of the enclosed
product against any defect in material or workmanship for a period of one year from
the date of purchase, with the exception of the elements which are warranted to
be free from defect in material and workmanship for ten years. In full satisfaction
of any claims under this Warranty the Manufacturer will repair or replace without
opinion are defective.
The Manufacturer shall not be responsible for any transportation or shipping
by it. Misuse of this product or repairs by persons other than the Manufacturer’s
authorized personnel without the Manufacturer’s written approval, will void this
Warranty.
This Warranty is in lieu of all other warranties or conditions whether expressed or
and shall constitute the sole remedy of the Purchaser and the sole liability of the
Manufacturer in respect of the sale of the product, whether in the nature of breach
or breach of fundamental term, or of negligence or otherwise.
The Manufacturer shall not be liable for any special, indirect or consequential
damages or for any damages resulting from removal or replacement of a linear
convector subject to warranty claim without the Manufacturer’s authorization.
This Warranty is transferable by the original consumer purchaser of the product.
N1R 7G8, Canada.
Warranty
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5
Figure 6
Min.
1.5" (3.8 cm)
Min.
1.5" (3.8 cm)
Min.
1.5" (3.8cm)
Min.
3" (7.6 cm)
Min.
3" (7.6 cm)
Min.
3" (7.6 cm)
Min.
6" (15.3 cm)
Min.
14" (35.6 cm)
Figure 7
A
B C D
Maintenance
CAUTION: Before removing the front cover for cleaning, make certain the
power has been turned off at the circuit breaker panel.
CAUTION:
before attempting to work on the linear convector.
The LC series contain no moving parts. Since the appliance contains no moving
parts little maintenance is required beyond vacuum cleaning. It is however
essential that the linear convector is not operated with an accumulation of dust or
dirt on the element, as this can cause a build up of heat and eventual damage.
For this reason the linear convector must be inspected regularly, depending upon
conditions and at least at yearly intervals. Once cleaning is complete replace the
front cover and restore power.
WARNING:
To Next Page
Loading...
Need help?
General
