PLEASE READ THIS ONLY IF YOU WANT TO CHANGE THE
PRE-SET TIMES
The Pre-set time of your heating system can be adjusted to suit your own life
style
Turn the Mode Selector Knob to
the position
The display will show P=1
Using the – and + buttons scroll
through to the correct zone P=1 is
zone 1, P=2 is zone 2 and so on.
If you go beyond the zone you
desire press the – button to go
back. When you have selected the
required zone press the OK button
to confirm
The display will now show
Using the – and + buttons scroll
through the hours at the bottom
selecting the appropriate mode
you want for that hour i.e. pressing
the – button the hour is selected
as Setback Mode and
pressing the + button the hour is
selected as Comfort Mode.
When you get to the 24th hour it
reverts back to hour 0, so if you
make a mistake just go through
the 24 hour period again selecting
the mode as before.
When you have set the day as you
desire press the OK button.
You can copy the same hours of
operation for the next day if you
wish. To do this keep the OK
button held down for a few
seconds, the day will change,
keep the OK button depressed
and the copied pre- set will
appear. If you do not wish to copy
the same hour just press the OK
button once and repeat the
process.
This line indicates
the hour in
Setback Mode
This line indicates
the hour in
Comfort Mode
The day of the week is indicated
by a number in the top right side
of the display
1= Monday, 2= Tuesday and so
on. To change the day without
altering the pre-set time press OK
Further Information
To Previous Page
Loading...
