DINAMIC OIL SE45 User Manual (English)

Other manuals for DINAMIC OIL SE45

Questions and Answers:

S
scott91Aug 5, 2025
What to do if DINAMIC OIL SE45 Winches load being lowered tends to fall?
- S
  Stephanie SmithAug 5, 2025
  If the load being lowered by your DINAMIC OIL Winches tends to fall, there could be a couple of reasons. First, there might be impurities in the valve. In this case, remove the valve and clean it with compressed air and naphtha. Also, check the cartridge of the circuit filter and replace it if necessary. Another possibility is that the cable is wound in the opposite direction to that indicated by the arrows. Rewind the cable in the correct direction.
K
Kristin BrownAug 11, 2025
Why DINAMIC OIL SE45 Winches hoist cannot lift the load?
- A
  asmithAug 11, 2025
  If your DINAMIC OIL Winches hoist cannot lift the load, it could be due to a couple of reasons. One possibility is insufficient pressure in the hydraulic circuit. Make sure the maximum-load valve on the control distributor is set correctly. Another reason could be a damaged motor. Check the drainage of the motor; if the flow of oil exceeds 1 liter per minute, replace the motor.
D
Dr. Scott ValenzuelaAug 17, 2025
What to do if DINAMIC OIL Winches with the distributor set in the center the load tends to go down?
- M
  Matthew SmithAug 17, 2025
  If, with the distributor set in the center, the load on your DINAMIC OIL Winches tends to go down, it might be due to excessively high counterpressure. Connect the drain of the motor directly to the tank to resolve this. Alternatively, the brake springs might be broken, in which case you should replace them.