8
STEPS FOR STARTING YOUR MACHINE
STEP 1
Mix the 2 stroke fuel to the correct
ratio (25:1)-(30:1) and fi ll the tank.
!SEE BELOW FOR FUEL INFORMATION
STEP 4
Slide the take on switch to the
down position.
STEP 7
Push in the lock-in button.
STEP 9
Pull the recoil 2–4 times. By the fourth
pull, it should sound like the engine is
going to start. Move to Step 8.
STEP 2
Press the fuel bubble 5–7 times (no
more than 7). Fuel should now fi ll the
tube next to pump.
STEP 5
Squeeze the top lever.
STEP 8
Follow through from step 7.
STEP 10
Slide the choke down to return it to
its original down position.
STEP 3
Slide the choke to the up position.
STEP 6
Pulling the bottom trigger.
STEP 11
Pull the recoil once again, or until
the engine starts.
CHOKE SETTINGS
OFF POSITION:
IS for initial starting
ON POSITION:
IS FOR THE RUNNING OPERATION OF THE MACHINE
To Next Page
Loading...
