diono.com01827 310557
16 17
Cup holders are located on both sides of seat
bottom: swivel outward to the locked position for
use.
Swivel inward to the recessed and locked position
when not in use.
IMPORTANT: Do not step on or put excess weight on the cup holder,
as this could cause it to break.
CAUTION: DO NOT use with hot liquids, as this could burn a child.
CARE AND MAINTENANCECUP HOLDER
CLEANING THE COVER
Read all labels attached to cover for washing instructions.
CLEANING THE SHELL
DO NOT use solvents, detergents or any other chemical or cleaning
agent. DO NOT lubricate any part of the seat.
REMOVING THE FABRIC COVER
1. Separate seat back section from seat bottom section.
2. Remove plastic fasteners and elastics that secure fabric cover to
seat bottom, seat back and headrest.
3. Remove fabric cover pieces from the booster seat sections.
ATTACHING THE COVER
Follow the above instructions in reverse.
Machine wash in cold
water on gentle cycle.
Use mild detergent.
CLEANING FABRICS: Seat Pad, Infant Support, Harness and Buckle Pad.
Dry flat and in
the shade only.
DO NOT bleach,
iron or dry clean.
30°
Spot clean only
with warm water.
Use mild detergent.
CLEANING HARNESS: Buckles, Harness and Buckle Straps.
Dry flat and in
the shade only,
before re-use.
DO NOT bleach
or iron.
Spot clean only
with warm water.
Use mild detergent.
CLEANING PLASTICS: Seat Shell and Components.
Towel dry
completely
before re-use.
DO NOT bleach.
•
Machine wash in cold
water on gentle cycle.
Use mild detergent.
CLEANING FABRICS: Seat Pad, Infant Support, Harness and Buckle Pad.
Dry flat and in
the shade only.
DO NOT bleach,
iron or dry clean.
30°
Spot clean only
with warm water.
Use mild detergent.
CLEANING HARNESS: Buckles, Harness and Buckle Straps.
Dry flat and in
the shade only,
before re-use.
DO NOT bleach
or iron.
Spot clean only
with warm water.
Use mild detergent.
CLEANING PLASTICS: Seat Shell and Components.
Towel dry
completely
before re-use.
DO NOT bleach.
40°
•
To Next Page