Need help?Do you have a question about the Directed Audio 750d 1500d and is the answer not in the manual?
Accepts line level audio signals from head units or processors.
Used for linking amplifiers in master/slave configurations.
Outputs a signal for bridged amplifier configurations.
Selects the amplifier's role (master or slave) in linked systems.
Connects to a remote knob to adjust subwoofer volume.
Connect subwoofers to these terminals for audio output.
Indicates amplifier operational status and protection modes.
Protects the amplifier from electrical damage.
Main power input connection for the amplifier.
Activates the amplifier when receiving a remote turn-on signal.
Connection point for the amplifier's ground to the vehicle chassis.
Sets the amplifier's sensitivity to match the source unit's output.
Adjusts the low-pass crossover point for precise system tuning.
Selects subsonic filter cutoff frequency, attenuating low bass.
Provides an 8dB boost for the subwoofer output.
Inverts the subwoofer output phase by 180 degrees.
Cover protecting the amplifier's top panel controls.
Instructions for removing and installing the control panel cover.
Links amplifiers master/slave for level matching and independent subwoofers.
Links amplifiers master/slave for common subwoofers using bridged output.
General| Channels | 1 |
|---|---|
| RMS Power at 4 Ohms | 750W |
| RMS Power at 2 Ohms | 1500W |
| Signal-to-Noise Ratio | 95dB |
| Input Sensitivity | 200mV - 6V |
To Next Page
