Directed 3121T - Standard Remote Configuration; 2-Button Transmitter; Arming

2 3
© 2019 Directed. All rights reserved. © 2019 Directed. All rights reserved.
Standard Remote Configuration
Function Button Action
Arm
A U X
Press and release
Disarm
A U X
Press and release
Panic
A U X
Press and hold (any system state)
Aux Output
A U X
+
A U X
Press and release (any system state)
Tilt bypass
A U X
Press and release within 5 seconds of arming
system
All Sensor Bypass
A U X
Press and release 2 times within 5 seconds
of arming system
Anti-Jacking (On & Off)
A U X
Press and hold (ignition on & system
disarmed)
Valet mode
A U X
+
A U X
Cycle ignition on & off twice, then press
and release
2-Button Transmitter
Arming
With the system disarmed and the ignition OFF, press the
A U X
button
once. The siren will chirp once, lights will flash once, and LED will
flash quickly. After 8 seconds, the system will fully arm, and LED
will flash slowly and engine will be disabled and all trigger zones
will be active.
Ignition Trigger
In armed mode, if the ignition is turned on, the system will be
triggered and the siren will sound, and the parking lights will flash
30 seconds. The system will repeat this 30 second cycle of siren
and parking light flashes until the ignition is turned OFF. After the
ignition is turned to OFF, the system will complete the current 30
second cycle before the siren and parking lights stop.
Tilt/Shock Sensor Trigger
1. Sensitivity for Tilt/Shock sensors are adjustable, see
FUNCTION SELECT MENU 1&2.
2. If the PowerSport vehicle is tilted/moved:
• If the system is in Sleep mode: At first, the siren will
chirp and parking lights will flash 10 times, then the
siren will sound continuously for 30 seconds with park-
ing light flashes.
• If the system is in Wake mode: The siren and parking
lights will trigger continuously for 30 seconds.
Note: Any alarm zone can be triggered up to 8 times per arming
cycle.
Arming and Bypassing Tilt Sensor
After arming the system, press
A U X
once within 5 seconds. The
system will emit one long chirp to indicate that the Tilt sensor is
bypassed. In this mode, the LED will flash twice every 2 seconds.
Arming and Bypassing Tilt and Shock Sensor
After arming the system, press
A U X
twice within 5 seconds, The
system will emit one long chirp to indicate that the Tilt sensor is
bypassed and then will chirp three more times to indicate that
shock sensor is also bypassed. In this mode, the LED will flash
twice every 2 seconds.