PROGRAMMING TO CONTROL YOUR TV
Now that you have successfully programmed the new
DIRECTV remote to operate your DIRECTV Receiver, you
will want to program this remote to control your TV.
1. Turn the TV on.
NOTE: Please read steps 2-5 completely before proceeding.
Highlight or write down the codes and component you wish to
program before moving on to step 2.
2. Locate the 5-digit code for your TV (see pages 13-16).
3. Move the slide switch to
TV
.
4. Press and hold in the
MUTE
and
SELECT
keys at the same
time until the green light under the
TV
icon flashes twice
and then release both keys.
5. Using the number keys enter the 5-digit code for your
brand of TV. If performed correctly the green light
under
TV
will flash twice.
6. Aim the remote at your TV and press the power key
once. The DIRECTV Receiver should turn off. If it does
not turn off, repeat steps 3 and 4, trying each code for
your brand until you find the correct code.
7. For future reference write down the working code for
your TV in the blocks below:
PROGRAMMING THE TV INPUT KEY
Once you have programmed the DIRECTV remote control for
your TV, you may want to activate the TV Input button.
1. Move the slide switch to the position under
TV
icon.
2. Press and hold the
MUTE
and
SELECT
keys until the green
light under the
TV
icon flashes twice and then release
both keys.
3. Using the number keys enter in
9-6-0
(The green light
under the
TV
icon will flash twice)
You now have the ability to control the Input select feature for
your TV.
DEACTIVATE THE TV INPUT SELECT KEY
If you want to hide the
TV INPUT
button, follow steps 1
through 3 from the previous section. Afterwards, the green
light will blink 4 times. Pressing the
TV INPUT
key will now do
nothing.
11
DirecTV-M2081A.qxd 12/22/2004 3:45 PM Page 11
To Next Page
Loading...
Need help?
General
