CONTROLLING DIRECTV RECEIVER
The DIRECTV Universal Remote Control is designed to give
you access to features and functions found on your original
remote control. To use it with your brand of DIRECTV
Receiver, you will need to program the remote control by per-
forming the following steps.
Programming DIRECTV Remote
1. Locate the DIRECTV Receiver's brand and model num-
ber (on the back or bottom panel) and write it in the
spaces below.
2. Locate the 5-digit code for your DIRECTV Receiver (see
page 10).
3. Power on the DIRECTV Receiver.
4. Move the slide switch to
DIRECTV
icon.
5. Press and hold in the
MUTE
and
SELECT
keys until the
green light under the
DIRECTV
icon flashes twice and
then release both keys.
6. Using the number keys enter the 5-digit code. If per-
formed correctly the green light under the
DIRECTV
icon
will flash twice.
7. Aim the remote at your DIRECTV Receiver and press
that the power key once. The DIRECTV Receiver should
turn off. If it does not turn off, repeat steps 3 and 4, try-
ing each code for your brand until you find the correct
code.
8. For future reference write down the working code for
your DIRECTV Receiver in the blocks below:
DIRECTV CODE:
BRAND:
MODEL:
9
DirecTV-M2081A.qxd 12/22/2004 3:45 PM Page 9
To Next Page
Loading...
Need help?
General
