Using your window vacuum
NOTE: You may need to
press the trigger a few
is dispensed, this clears
air from the system.
Remove the spray bottle
head by turning anticlock-
wise. Fill the spray bottle
with water.
Turn on the window vacuum
by pressing and holding the
the window vacuum simply
Pull the trigger to spray
water onto the surface to
be cleaned.
Vacuum up the water using
slow, straight, downwards strokes.
Ensure that the squeegee has
good contact with the surface by
keeping the window vacuum as
parallel to the surface as possible.
Wipe the surface with the
spray bottle.
NOTE:
the cleaner after each use. The cleaner should not be stored for more than two months without being recharged.
WARNING! Never operate the cleaner if the water level in main waste water tank exceeds the Max line, or if there
is water in the secondary waste water tank. Empty the waste water tanks before continuing to use the cleaner.
Using your machine Taking care of your machine
NOTE: The window vacuum and spray bottle must be emptied after each use. Do not store water in the window
vacuum and spray bottle between usage.
After every use
Remove the spray bottle
head by turning anticlock-
wise and empty the bottle
after each use.
Gently pull the waste water
tank plugs on the window
vacuum and ensure each
waste water tank is empty
after each use.
Remove the suction head
and wash the squeegee
under running water (Max
40°C) to remove dirt and
debris. Wipe the squeegee
with a damp cloth to
remove any excess water.
To Next Page
Loading...
