DiscoSmash DSG-X10 User Manual

DSG-X10 User Manual
• Connections:
The soundbox can be connected in 2 ways:
1. If you have a Discosmash mixing panel:
Use the AMP-DS connector. This connects to the “EXT” connection of the mixing panel.
The Output, Input and Power connections are not used.
2. If you don’t have a Discosmash mixing panel:
You need to connect the output of the CD-player (or other music source) to the Input of the
soundbox. The Output of the soundbox connects to your mixing panel or amplier, where
the CD-player was previously connected. A 9V AC power adapter is connected to the
Power connection.
The Ext. connector is for external expansions and won’t be used in most cases.
The Remote connector can be used to activate a sound remotely by shorting the 2 pins.
(i.e. with an external switch or relays contact)
• General:
Make sure there is a SD memory card with the correct contents in the slot.
On start-up rst the software version will be displayed.
After this, if the card can be read correctly, the selected bank will be displayed (“b01”
means that bank 1 is now active).
Each of the 10 buttons will activate a sound. The volume + and - buttons will change the
volume (between 0 and 50) and save it.
DSG-X10
DSG-X10
Discosmash
Vroegeinde 14, 2243 Pulle, Belgium
Tel.: +32 (0)3 4640909 - Fax: +32 (0)3 4640139
info@discosmash.com - www.discosmash.com
MANUAL
MANUAL

DiscoSmash DSG-X10 Specifications

General

Brand	DiscoSmash
Model	DSG-X10
Category	Antenna
Language	English

Summary

DSG-X10 Device Connections

Connecting with Discosmash Mixing Panel

Use the AMP-DS connector for connecting to a Discosmash mixing panel. Output, Input and Power are not used.

Connecting Without Discosmash Mixing Panel

Connect music source output to soundbox Input, and soundbox Output to your mixer/amplifier.

External Expansion and Remote Control

Ext. connector for external expansions. Remote connector activates sound by shorting pins.

DSG-X10 General Operation

General Setup and Startup

Ensure SD card has correct contents. Software version displays on startup, then active bank (e.g., 'b01').

Sound Activation and Volume

Each of 10 buttons activates a sound. Volume +/- buttons adjust volume (0-50) and save.

DSG-X10 Soundbox Features

Stopping a Sound

Push the Power button to stop a playing sound or switch off the unit if no sound is playing.

Switching Banks

Hold Power, push bank number, release Power. Use 'Pre' error for missing settings.

Timers for Automatic Playback

Program intervals by setting sounds and pause times. Timer shows 'P--' while playing.

Volume Offsets for Individual Sounds

Adjust individual sound volume offset (-50 to +50) by holding button and using volume controls.

Input Sensitivity Adjustment

Adjust input sensitivity (-23 to +8 dB) by holding Vol +/- on startup.

Changing Sounds and Settings

Modify sounds/settings by placing the memory card in a DSR-X20 or PC software.

Error Message Interpretation

Understand error codes like 'crd', 'Pre', 'Clp' related to card, settings, or distortion.

Software Update Procedure

Update software by placing file on SD card and holding Vol +/- during power reconnect.