DiscountRamps BC-8407-2 User Manual

Spare mount bike rack
MODEL: BC-8407-2
INSTRUCTIONS
×1
×1
×1
×1 ×1 ×1×1 ×2 ×1 ×1 ×1
×1
2
Install the connecting tube to the back plate. Caution: select
the right size of the connecting tube according to the chart.
3
Install the back plate onto the car. You may need to position
the back plate according to the position of the bolts.
4
Install the tire back to car. Tighten it with the nuts.
5
Secure the upper part of rack to lower part with
bolts and nuts.
6
Use the locking knob to secure the rack to car.
change
1
Remove the spare tire from the car.
Tire Width (read the size located at the side of your tire)
195mm-235mm - Use the short connecting tube
235mm-275mm - Use the medium connecting tube
285mm-12.5" (318 mm) - Use the long connecting tube
Some tires must require the use of connecting tubes with different sizes of these above. If you can not
tighten rack properly, then use a shorter connecting tube. On the other hand, if you can see the tick
mark line, use a longer connecting tube.
Caution: please double check that the tick mark line (shown with red line) is fully covered.
If it is not covered, please change to longer connecting tube.

DiscountRamps BC-8407-2 Specifications

General

Brand	DiscountRamps
Model	BC-8407-2
Category	Automobile Accessories
Language	English

Summary

Spare Mount Bike Rack Assembly and Usage

Prepare Vehicle for Rack Installation

Remove the spare tire and select the correct connecting tube size based on tire width.

Install Rack Components and Secure to Vehicle

Attach connecting tube, mount back plate, secure upper to lower rack parts, and use locking knob.

Mount and Secure Bicycles

Lock the rack, secure bikes with Velcro and safety straps for wheels and frames.

Important Safety and Operational Guidelines

Operational Tips and Storage

Rotate rack when not in use; check bike securing methods and vehicle handling.

Critical Safety Warnings

Ensure secure attachment, avoid exhaust pipes, maintain equipment, and check before journeys.