Dish Network Dual-Tuner OTA Adapter User Manual

TM
Set Up Your
Dual-Tuner
OTA Adapter

Dish Network Dual-Tuner OTA Adapter Specifications

General

Type	Dual-Tuner OTA Adapter
Tuners	2
Connectivity	USB
Compatibility	Dish Network Hopper and Wally receivers
Function	Receives and decodes Over-The-Air (OTA) broadcast signals
Power Source	Powered via USB from receiver
Input	Antenna input for OTA signals
Channels	Varies by location and signal strength

Summary

Step 1: Connect Antenna to Adapter

Connect Antenna to Dual-Tuner OTA Adapter

Connect your antenna to your Dual-Tuner OTA Adapter using your coaxial cable. Then, turn on your TV and your receiver.

Step 2: Connect Adapter to Receiver

Connect Adapter to Receiver via USB

Connect your Dual-Tuner OTA Adapter to your receiver by plugging the USB end of the adapter into a USB port on your receiver.

Troubleshoot Connection with USB Extension

Step 3: Restart Receiver

Confirm OTA Tuner Module Detection

When the popup appears on your TV, highlight the "Yes" option and press the Select button on your remote to restart your receiver.

Step 7: Initiate Channel Scan

Start Over-the-Air Channel Scan

Use the arrows on your remote to highlight the "Scan" option, then press Select to begin scanning for local channels.

Step 9: Select Channels for Guide

Choose Channels to Display in Guide

Choose the channels you want in your guide by highlighting them and pressing Select. Press and hold the Back button.