Transport - 40 SK500 Operator’s Manual
Tow
CMW
Return Unit to Normal Operation
1. Screw in bypass valve pins and torque to 12.5 ft•lb
(17 N•m).
2. Remove rear access panel.
3. Remove brake pin bolts (3).
4. Push out pins (2) on tracks.
5. Attach end of both springs (1) through hole in each side of frame.
6. Stretch springs and install brake pin bolts in the same holes they were removed from.
7. Install rear access panel.
IMPORTANT: Close bypass valve in both
front and rear pumps.
IMPORTANT: Note which holes brake pin bolts are installed in for proper reinstallation. “A”
represents narrow track configuration. “B” represents wide track configuration.
t05om031c.eps
A
B
2
3
3
1
To Next Page