SK500 Operator’s Manual Transport - 39
Tow
CMW
Tow
Under normal conditions, unit should not be towed. If unit breaks down and towing is necessary:
• attach chains to tow points facing towing vehicle
• tow for short distances at less than 1 mph (1.6 km/h)
• do not tow for more than 100 ft (30 m)
• use no more than 1,300 lb (5800 N) of towing force
• disengage brakes and open bypass valve
Prepare Unit for Towing
1. Block tracks.
2. Insert pry bar between end of spring (1) and frame.
3. Rotate spring up and allow it to move through
vertical slot.
4. Drive in pin (2) in until sprocket teeth clear it.
5. Unscrew bypass valve pins (shown) 3 turns.
6. Repeat process on other side.
IMPORTANT: Open bypass valves in both
front and rear pumps.
t05om004c.eps
t05om028c.eps
1
2
To Next Page