Complete the Job - 56 SK600 Operator’s Manual
Rinse Equipment
Rinse Equipment
1. Spray water onto equipment to remove dirt and mud.
2. Remove mud from track sprockets.
3. Wash undercarriage. Pay special attention to brake pin area.
Disconnect Attachment
1. Lower attachment to the ground.
2. Shut off machine.
3. Disengage lock pins by lifting handles upward.
4. Cycle attachment drive control and disconnect hydraulic hoses, if needed.
5. Start engine.
6. Tilt mount plate forward and back machine away from attachment.
Stow Tools
Ensure all tools and accessories are loaded and properly secured on trailer.
NOTICE:
• Do not spray water onto operator’s console or electrical center in engine compartment. Water can
damage electrical components. Wipe down instead.
• Ensure all mud and debris is rinsed from tracks before parking unit overnight.
To Next Page
Loading...
