Iron Mountain Refrigeration & Equipment, LLC
Dixell XR06CX Temperature Control Manual
833-734-8880
service@ironmountainrefrigeration.com
Thank you for your freezer purchase. Your digital temperature controller should arrive pre-set to factory
standards. This manual is provided to assist with any small changes you may wish to make. If you are
experiencing any issues with the function of your cooler, we are available for support at
service@ironmountainrefrigeration.com or by phone at 833-734-8880.
Your freezer is designed to maintain a temperature range with a high and low setting. When the high
temperature is reached, the compressor will start and run until the low temperature is reached. Setting
the high and low too close may cause ice build up and compressor failure.
To see your set temperature, press and release “SET”. To change it, hold “SET” until F is flashing and use
up or down to adjust. This temperature must be within the selected temperature range in the
parameters. To check or adjust the parameters, follow the steps below.
1. Hold “Set” and “Down” together for 3 seconds until F is flashing. Release. Hold “Set” and
“Down” again for 10 seconds until “L2” is shown.
2. You are now in the parameter menu. The first parameter, “Hy” is shown.
a. Press “Set” to see the current setting.
b. Use Up and Down arrows to change, if needed.
c. Press “Set” to show next parameter.
3. To exit and save changes, press “Set” and “Up” together.
To Next Page
