dji Aeroscope - Page 5

Aeroscope Stationary Unit Installation
4
©
2018 DJI All Rights Reserved.
3. Connect the antennas to the unit via the antenna cable.
a. If using G8 directional antennas, connect each antenna to one antenna port of the
stationary unit with an antenna cable. Note that two adjacent antennas should be
connected to ports at the top of the stationary unit, while the other two adjacent
antennas should be connected to ports at the bottom. This ensures diversity gains will
be realized. Figure 5 shows the connection conguration between the G8 antennas and
the stationary unit.
b. If using G16 high-gain antennas, the 2.4GHz antenna should be connected to a 5.8GHz
antenna. Each 5.8GHz antenna has two antenna cable ports. The port marked “OUT” is
for connecting to the Aeroscope unit, and the port marked “IN” is for connecting to the
2.4GHz antenna. Figure 6 shows the connection conguration and close-up view of a
2.4GHz antenna.
Figure 4. Attaching the G16 antennas to the pole
Figure 5. Connection conguration
between G8 antennas and the
stationary unit
Figure 6. (a) The connections between the 2.4GHz antennas and the 5.8GHz antennas
in G16 antennas installations. (b) The “IN” and “OUT” ports on a 5.8GHz G16 antenna.
(a) (b)