dji Aeroscope - Temporary Setup

Aeroscope Stationary Unit Installation
certicate manually.
To import a new certicate, follow this procedure:
1. Acquire the certicate les from DJI. A single certicate consists of two les.
2. Download DJI Assistant 2.
3. Install and run DJI Assistant 2 on a windows computer (desktop or laptop).
4. Connect the computer and the Aeroscope unit to the same router or connect them directly
via the Ethernet port.
5. After the stationary unit is found in Aeroscope, click it to enter the unit page. Under
Advanced Functions, select the certicate. Import the certicate by selecting both les.
Temporary Setup
The Aeroscope stationary unit can be set up temporarily for urgent temporary events. In these
scenarios, a tripod and battery are typically required for installation and power.
The Aeroscope portable unit has the advantage that no installation time is required. However,
the Aeroscope stationary unit temporary setup has a longer detection range and supports
Figure 8. Temporary setup of the Aeroscope stationary unit
Copyright © 2018 DJI All Rights Reserved.
This content is subject to change.
Download the latest version from
https://www.dji.com/aeroscope
If you have any questions about this document,
please contact DJI by sending a message to
DocSupport@dji.com
.