dji AIR 3

DJI Air 3
User Manual
©
2023 DJI All Rights Reserved.
25
Auto Landing
Use the Auto Landing function:
1. Tap
. If conditions are safe for landing, press and hold the button to conrm.
2. Auto landing can be cancelled by tapping
.
3. If the Downward Vision System is working normally, Landing Protection will be enabled.
4. Motors will stop automatically after landing.
• Choose the proper place for landing.
Starting/Stopping the Motors
Starting the Motors
Perform the Combination Stick Command (CSC) as shown below to start the motors. Once the
motors have started spinning, release both sticks simultaneously.
Stopping the Motors
When the aircraft is on the ground and the motors are spinning, there are two ways to stop the
motors:
Method 1:
When the aircraft has landed, push the throttle stick down and hold until the
motors stop.
Method 2:
When the aircraft has landed, perform the same CSC used to start the motors until
the motors stop.
Stopping the Motors Mid-Flight
Stopping the motors mid-ight will cause the aircraft to crash. The default setting for Emergency
Propeller Stop in the DJI Fly app is Emergency Only, which means that the motors can only
be stopped mid-flight when the aircraft detects that it is in an emergency situation such as
the aircraft is involved in a collision, a motor has stalled, the aircraft is rolling in the air, or the
aircraft is out of control and is ascending or descending very quickly. To stop the motors mid-
OR
Method 1 Method 2
OR