dji AVATA 2 - Updating Firmware

DJI Avata 2 User Manual
94
©
2024 DJI All Rights Reserved.
Updating Firmware
Use one of the following methods to update the rmware:
1. Use the DJI Fly App to update the rmware for the entire set of devices including the aircraft,
goggles, and remote control device.
2. Use DJI Assistant 2 (Consumer Drones Series) to update the rmware for a single device.
Using DJI Fly
Power on the aircraft, goggles, and remote control device. Make sure all the devices are linked.
Connect the USB-C port of the goggles to the mobile device, run DJI Fly, and follow the prompt
to update. An internet connection is required.
Using DJI Assistant 2 (Consumer Drones Series)
1. Power on the device. Connect the device to a computer with a USB-C cable.
2. Launch DJI Assistant 2 (Consumer Drones Series) and log in with your DJI account.
3. Select the device and click Firmware Update on the left side of the screen.
4. Select and conrm the rmware version to update to.
5. Wait for the rmware to download. The rmware update will start automatically.
6. The device will restart automatically after the rmware update is complete.
• If there are any additional batteries that need to be updated, insert the battery into
the aircraft and power on the aircraft. A prompt will appear in the goggles to update
the battery. Make sure to update the battery before takeo.
• Make sure to follow all the steps to update the rmware, otherwise the update may
fail.
• Make sure the computer is connected to the internet during the update.
• Do not unplug the USB-C cable during an update.
• The rmware update will take several minutes. During the update process, it is normal
for the gimbal to go limp, the aircraft status indicators to blink, and the aircraft to
reboot and beep. Wait patiently for the update to complete.
• Before performing an update, make sure the goggles are at least 20% charged and the
remote control device is at least 15% charged.
• Note that the update may reset various ight parameters, such as the RTH altitude
and the maximum flight distance. Before updating, take note of your preferred
settings and readjust them after the update.
• DO NOT use Hardware and Software that is not specied by DJI.
Visit the following link and refer to the Release Notes for rmware update information:
https://www.dji.com/avata-2/downloads