DJI Avata 2 User Manual
©
2024 DJI All Rights Reserved.
99
• DO NOT pull the sides when removing the foam padding. Otherwise, the padding
may be damaged.
Maintenance
Replacing the Foam Padding for Goggles
1. Hold the bottom of the foam padding and remove it gently, as shown below.
2. Align the positioning columns of the new foam padding with the positioning holes on the
goggles. Install it and press along the contour. After hearing a "click," check and make sure
that there is no gap between the foam padding and the goggles.
To Next Page
Loading...
