dji D-RTK - Appendix; Specifications

EN
11
Screen
Interface Descriptions
The interface consists of ve parts:
BS
Ready
Fixed
GNSS:16
Device Type
Battery Level
NoticationsGNSS Status
System Status
Display Descriptions
Determine the system status via prompts on the screen. Resolve any potential
issues if an abnormal status is displayed.
The language can be switched to English or Chinese using DJI Assistant 2.
Displays Descriptions
RTK Mode and Signal Strength
BS
Base Station mode. Link and use the mapper in this
mode when used with D-RTK Base Station
RC
Network RTK Mode via the remote controller. This mode
is not supported yet.
Data transmission signal strength.
System Status
System Initializing
The system is initializing. The system will remain in
this state for an extended time if there are not enough
satellites for positioning. Make sure that the D-RTK Base
Station is working normally and move the mapper to a
location where there is a strong satellite signal within the
transmission range of the base station.
Ready The mapper is working normally.
Linking with BS Linking with the base station.