EN
12
Linking Successful Linked with the base station.
Locating Satellites
Satellite signal is weak. Measurement cannot be continued
in this status. Check if there is any obstruction or
interference. Then wait for display on the screen back to
what it was before to continue measurement.
Edge X-Y
Measuring the edge of the eld. “X” means the recorded
point number for the edge measurement, and “Y” means
the recorded calibration point number.
Obstacle Z-N
Measuring obstacle. “Z” means the recorded point number
around the obstacle and “N” means the Nth obstacle being
measured.
No SD Card!
No Micro SD card detected. Insert an available card
correctly.
File Error!
File storage error. Check if the Micro SD card is damaged
or if it has enough free space. The max supported SD
card capacity is 16 GB. Check if the capacity is at or
below 16 GB.
Activate in Software
Device not activated. Connect it to DJI Assistant 2 for
activation.
GNSS Status
GNSS: XX
GNSS board initialization succeeds. XX indicates the
number of satellites.
N/A
GNSS board initialization failed. Please contact DJI
Support or an authorized dealer.
Notications
>>>--
Arrows will appear and disappear to indicate system
initialization.
Fixed
The position of the mapper is conrmed.
To Next Page
Loading...
