dji D-RTK - Page 14

EN
13
Not Fixed
The position of the mapper cannot be obtained. This
may be caused by cable connection issues, damage,
obstruction, interference, or insucient satellite signal for
the base station positioning. If troubleshooting doesn't
work, contact DJI Support or an authorized dealer.
No BS Data
No base station data received. This may be caused
by cable connection issues, damage, obstruction, or
interference, or being too far away from the base station.
If troubleshooting doesn't work, contact DJI Support or an
authorized dealer.
Indicator Key
Indicator Light Descriptions
—— Solid Green Ready.
Blinking Red System initializing.
—— Solid Red System error. Check the notications on the screen.
Updating Firmware
1. Turn on the mapper and connect it to DJI Assistant 2. There will be two connected
devices.
2. Click each device and download the latest rmware on the Firmware Update page,
and then follow the instructions to complete updates. Make sure to update the
rmware for both devices.
3. Restart it manually after the rmware update.