EN
6
The maximum run time of a fully charged battery is approximately ve hours.
USB power supply port can be used to charge a 5V/2A mobile device.
Refer to the Charging Hub (WCH2) User Guide and the Intelligent Battery
(WB37) Safety Guidelines for more details.
http://www.dji.com/crystalsky/info#downloads
Installation
Battery Installation
Charging the Battery
Press the battery level button once to check the battery level. Fully charge the
batteries before rst-time use.
1. Place the battery into the Charging Hub, connect the charger to the Charging
Hub, and then connect the charger to a power outlet (100–240V, 50/60Hz).
2. The Charging Hub will intelligently charge batteries in sequence according to
battery power levels from high to low.
3. The Status LED blinks green when charging and turns solid green when fully
charged. The buzzer will begin beeping when charging is complete. Remove
the battery or turn off the buzzer to stop it.
To Next Page
Loading...
