EN
7
Mounting the Battery
1. Loosen the screw on the battery compartment
cover, then remove the cover.
2. Place the battery into the battery compartment
securely.
3. Re-mount the cover and tighten the screw.
Pole Installation
Insert the pole into the bottom of the mapper and rotate it until it tightens.
Turn the Mapper On/Off
Press the power button of the mapper, then again and hold to turn it on or off.
The mapper will turn off automatically if it is idle (i.e. there are no button inputs on
the operation panel) for 30 minutes.
Activation
Make sure to activate the mapper using DJI ASSISTANT
TM
2 before rst-time use.
1. Visit the official DJI website. Download and install the latest version of the DJI
Assistant 2 software.
http://www.dji.com/mg-1s/info#downloads
To Next Page
Loading...
