dji D-RTK - Connection; Usage; Configuring Parameters Using DJI Assistant 2

EN
8
2. Turn on the mapper. Connect it to your computer via a Micro USB cable.
3. Run DJI Assistant 2 and click “MG-1S RTK”. Activate the device following the
instructions in the pop-up window.
4. Restart the mapper manually after activation.
DO NOT change any of the settings in DJI Assistant 2. Use the product
under the default settings.
If there is no device linked with the base station when beeping, it will exit
linking and stop beeping automatically.
Press the power button on the base station or mapper once to cancel when
linking is initiated.
Linking is required only for rst-time use with the same mapper and base
station. The two will connect to each other automatically during future use.
Linking
1. Turn on the D-RTK Base Station. “GNSS” in the lower left corner of the screen
indicates a successful start.
2. Turn on the mapper. “GNSS” in the lower left corner of the screen indicates a
successful start.
3. Ensure that the upper left corner of the screen shows “BS”, which indicates Base
Station RTK Mode. If it shows “RC”, press and hold the Mode button to switch to
“BS”.
4. Press and hold the Link button on the mapper. “Linking with BS” on the screen
indicates that the mapper has initiated linking.
5. Press and hold the Link button on the base station and it will beep for ve seconds.
“Linking Successful” on the screen of the mapper during beeping indicates
successful linking.