7
EN
1
3
2
U
P
D
o
w
n
T
u
r
n
R
i
g
h
t
T
u
f
t
F
o
r
w
a
r
d
B
a
c
k
w
a
r
d
R
i
g
h
t
L
e
f
t
5. Prepare the Remote Controller
Unfold the mobile device holder and the antennas.
Optimal Transmission Range
Try to keep the aircraft inside the
optimal transmission range. If the
signal is weak, adjust the antennas
or y the aircraft closer.
Place your mobile
device and adjust the
clamp to secure.
Press the button to
release the clamp.
Connect your mobile
device with a Micro USB
cable.
Dual Remote Controllers
You are required to link the Master
and Slave remote controllers.
Regarding the Master RC, launch
the DJI GO 4 app and enter GO FLY.
Tap on the top of your screen
to enter the RC Settings. Set the RC
Status as ‘Master’, and then enter the
desired connection password.
Repeat to set Slave RC Status to
‘Slave’. Then tap Search for Master
RC and connect to the Master RC
with your preset password.
Strong Weak
Dual frequency support makes the HD video downlink more stable. Note that the Russian only have the 2.4G frequency.
DO NOT operate more than 3 aircrafts within the same area (size equivalent to a soccer eld) to prevent transmission interference.
6. Controls
The stick mode is set to Mode 2 by default (left hand throttle). The left stick controls the aircraft's elevation
and heading. The right stick controls the aircraft's forward, backward and lateral movements. To adjust the
FPV camera, press and hold the C2 Button and rotate the control dial.
Left Stick FPV Camera ControlsRight Stick
You can change the stick mode in the DJI GO 4 app.
Remote Controller Status Indicator
RC normal and connected to aircraft. ( B...) Low battery warning / RC error.
RC Slave Mode and not connected to aircraft. (
B—B—...) RC idle for 5 minutes.
RC normal but not connected to aircraft. RC Slave Mode and connected to aircraft.
Unfold
5.8G 2.4G
90。 60。
To Next Page
Loading...
Need help?
General
