dji MATRICE 600 Maintenance Manual

I. Checking the Battery
1. EnsurethatyourrmwareandDJIGOappareup-
to-date.LaunchDJIGOapptoconrmthatallthe
batterycellsarefullychargedtothesamevoltage
level.Ifallthecellsareabove3.7Vbutonecelldiffers
by0.2Vormore,contactDJI
TM
foranalysis.Youcan
alsocheckthebatterywarninghistory.Ifanywarning
isreported,contactDJI.
2. Checktheelectrodesinthebatterycompartment.
Return-to-factoryservicewillberequirediftheyappear
severelyburnt.
3. Check the battery compartment’s plastic components
to ensure that they are in good condition and that all
screws are secure. This prevents the battery from
becoming loose during ight.
4. Check the contact pins in the battery compartment
to ensure that they are clear. They should be able to
establish easy contact with the battery and should not
be bent.
5. Check the battery for damage and deformities. If there
are any signs of severe damage to the battery, stop
using it and discharge the battery to 10% or below
for disposal. Do not disassemble the battery for any
reason.
6. Check the battery’s gold ngers besides the battery
port and rub them clean with an eraser if any residue
is observed. This will help to ensure a more reliable
connection.
7. Check the battery port’s metal connectors for damage.
Replace the battery immediately if the connectors
appear severely burnt.
8. For long term storage, refer to the Intelligent Flight
Battery Safety Guidelines and check the battery once
a month to avoid damage to the battery.
II. Checking the Center Frame
1. Check the upper and lower plates of the center frame
for cracks and damage. If wear exists, but you’re not
sure whether it is safe to y, contact DJI Support for
help.
2. Check the red knob for wear, e.g. if the frame arm is
loose after the knob is locked. If it is, replace the knob
with a spare knob that comes with the MATRICE
TM
600.
3. Turn on the aircraft and listen for any abnormal noise
or vibration from the cooling fan located on the upper
cover of the aircraft. If a loud noise is detected,
replace the fan.
4. Check the damper on the ight controller for wear and
severe deformities.
5. Checkallthecableconnectionsontheightcontroller
andLightbridge2AirSystem.
6. Checkthesquareheadscrewsonthepowercablesof
theframearmatthebottomofthecenterframe.Use
thesquaresocketwrenchthatcomeswiththeMatrice
600totightenthescrewsifloose.
7. Check the screws connected to the expansion mounting
kit and center frame. Apply medium strength threadlocker
and then tighten the screws if loose.
8. Check the screws connected to the retractable
modules and center frame. Apply medium strength
threadlocker and then tighten the screws if loose.
III. Checking the Foldable Frame Arms
1. Check if the frame arm can move freely, e.g. if the
frame arm is loose after the knob is locked. If it is, but
the knob is in good condition, tighten the screw at the
connection point.
To ensure optimal performance and ight safety for your aircraft, comprehensivemaintenanceisrecommended
every50ightsorafteryingforover20hours.This manual is intended to help users maintain their aircraft for
maximum reliability.
Maintenance Manual
MATRICE 600
2016.06
V1.0
1
Screw

dji MATRICE 600 Specifications

General

Product color	Black, Red
Battery voltage	22.2 V
Battery capacity	4500 mAh
Transmitter battery capacity	6000 mAh
Maximum speed	18 m/s
Frequency band	2.4 - 5.825 GHz
GPS (satellite)	Yes
Number of rotors	6 rotors
Maximum tilt angle	25 °
Hovering time (max)	35 min
Hovering time (min)	16 min
Maximum ascent speed	5 m/s
Maximum descent speed	3 m/s
Maximum weight capacity	- kg
Maximum wind resistance	8 m/s
Vertical hover accuracy	0.5 m
Horizontal hover accuracy	1.5 m
Maximum operating distance	5000 m
Maximum yaw angular velocity	150 °/sec
Maximum pitch angular velocity	300 °/sec
AC adapter power	100 W
AC adapter output voltage	26.3 V
Operating temperature (T-T)	-10 - 40 °C
Moving control functions	-
Package depth	320 mm
Package width	620 mm
Package height	505 mm
Operating frequency	920.6 MHz to 928 MHz (Japan), 5.725 GHz - 5.825 GHz, 2.400 GHz - 2.483 GHz MHz
Maximum device width	170 mm
Cables included	AC, Micro-USB

Weight and Dimensions

Depth	1518 mm
Width	1668 mm
Height	759 mm
Battery weight	595 g
Wheelbase diagonal	1133 mm
Takeoff weight (max)	15100 g
Weight (including battery)	9100 g