dji Matrice M30 - Introduction; In the Box; Preparing the Aircraft

Introduction
DJI
TM
MATRICE
TM
30 Series Dock Version aircraft can be linked to DJI Dock Version. With DJI FlightHub 2, it can be
used to perform automated operations remotely.
In the Box
Aircraft* ×1
with microSD card inserted
Screws and Tools ×1 1671 Propeller ×2 1671 Propeller ×2
CW
CCW
* The M30 Dock Version and M30T Dock Version are equipped with different cameras. Refer to the actual product
purchased. This guide uses the M30T aircraft as an example.
Preparing the Aircraft
 Make sure the propellers are securely mounted and not damaged or deformed and that
there are no foreign objects in or on the motors or propellers.
 Make sure the lenses of the vision systems, gimbal cameras, FPV camera, the glass of the
infrared sensors, and the auxiliary lights are clean and not blocked in any way, and the
protective stickers are removed.
 Make sure the waterproof rubber port covers are correctly in place and securely sealed.
1. Unfold the frame arms on both sides in the same way. Make sure the frame arm folded buttons pop out so
that the frame arms are locked firmly.
2. Make sure the gimbal camera is facing forward laterally.
3. Insert two TB30 batteries (purchased separately). Make sure the battery release toggles are in the same
position as shown in the diagram.