Installation Guide
Upon receipt of your DJI O3 Air Unit, attach the air unit onto the aircraft before
proceeding. For a step-by-step guide to installing your device, refer to the steps
below.
1. Insert or solder the 3-in-1 cable plug into the socket or solder joints of the
aircraft flight control board.
* The cable sequence of different flight controllers may be different. It is
recommended that you check whether the cable sequence is correct before
attaching and using.
2. Mount the air unit onto the aircraft, and check whether it is installed securely.
3. Arrange the camera coaxial cable to avoid winding with other cables.
4. Fit four screws in each side of the camera module. (Note that the depth of the
screw hole is 2 mm. Make sure not to tighten the screw too much. Applying too
much pressure will snap the screw, and thereby damage the circuit or FPC within
the camera.
5. Mount the antenna module on the aircraft, and check whether it is installed
securely.
6. Arrange the cables, and secure the aircraft with screws.
Watch this video for the more details.
To Next Page
Loading...
