EN
6
6. Flight
Ready to Go (GPS)
Before taking o, make sure the Aircraft Status Bar in the DJI GO 4 app
indicates ‘Ready to Go (GPS)’ or ‘Ready to Go (Vision)’ if ying indoors.
In the DJI GO 4 App:
Manual Takeo Manual Landing
Auto Takeoff
The aircraft will take off and hover at
an altitude of 4 feet (1.2 meters).
Auto Landing
The aircraft will land vertically and stop its
motors.
Return-to-Home (RTH)
Bring the aircraft back to the Home
Point. Tap again to stop the procedure.
Normal
You are in control of the Phantom, with
satellite and Return-to-Home support.
ActiveTrack
Mark an object on your screen to track it
as it moves.
TapFly
Tap on your screen to fly your Phantom
in that direction, avoiding obstacles as it
flies.
●
Watch the tutorial in the DJI GO 4 app or on the ocial DJI website to learn more.
●
Always set an appropriate RTH altitude before takeo. When the aircraft is returning to the Home Point, you should
guide it with the control sticks. Refer to the Disclaimer and Safety Guidelines for more details.
●
Rotating propellers can be dangerous. Do not start the motors when there are
people nearby.
●
Always keep your hands on the remote controller so long as the motor is still
spinning.
●
Stop motor mid-ight: Pull the left stick to the bottom inside corner while
simultaneously pressing the RTH button. Only stop motors mid-ight in
emergency situations when doing so can reduce the risk of damage or injury.
Refer to the user manual for details.
OR
Combination Stick Command
to start/stop the motors
Left stick up (slowly)
to take o
Left stick down (slowly)
until you touch the ground
Hold a few seconds to stop
the motors
Stop motor mid-ight
It’s important to understand basic ight guidelines, for the safety of both you and those around you. Don't forget to
read the Disclaimer and Safety Guidelines.
To Next Page
Loading...
Need help?
General