dji Ronin - DJI Intelligent Battery Functions; Battery Specifications; Charging the Intelligent Battery

©
2016 DJI. All Rights Reserved.
9
Ronin
User Manual
Getting Started
DJI Intelligent Battery Functions
Balance Charging Automatically balances the voltage of each battery cell during charging.
Capacity Display Displays current battery levels.
Overcharge Protection Stops charging if its voltage is too high.
Over Discharge Protection Stops discharging if its voltage is too low.
Short Circuit Protection Automatically cuts power supply when a short circuit is detected.
Sleep Protection Sleep mode is activated after 20 minutes of inactivity to save power.
Charging Temperature Detection The battery will charge only when the temperature is between 5℃
and 40℃.
BatterySpecications
Type LiPo
Capacity / Voltage 4350 mAh, 15.2 V
Charging Environment Temperature 5°C ~ 40°C
Operating Environment Temperature -15°C ~ 50°C
Charging/Discharging Environment Relative Humidity <80%
Ronin Charger and Intelligent Battery Models
New Intelligent Battery 844297-4350mAh-15.2V New Charger A14-057N1A
Old Intelligent Battery 824380-3400mAh-14.8V Old Charger MDA10116803000
Read the user manual, disclaimer, and battery warnings before use. Users take full
responsibility for all operations and usage.
DO NOT use the new charger to charge the old battery, or else the battery will be damaged.
The old charger will only charge the new battery to 90%, and you should disconnect the
battery after 1.5 hours of charging.
Always use DJI approved chargers. DJI takes no responsibility for any use of non-DJI
approved chargers.
Charging the Intelligent Battery
1. Connect the charger to a wall socket (100-240V, 50/60Hz), using the plug set if necessary.
2. Connect the battery to the charger.
3. The battery level indicator lights display current capacity level as the battery charges.
4. The battery is fully charged when the battery level indicator lights shut off. Disconnect the battery
from the charger when charging is completed.