©
2014 DJI. All Rights Reserved.
5
In The Box
Center Frame ×1 Frame Arms ×6
Landing Skid Tubes ×2
(with Silicone Rubber Dampers)
Landing Gear Legs ×2
GPS Collapsible Mount ×1 Springs ×2
Connector Set ×1 3-PIN Servo Cable ×1
Screw Package ×1 Accessories Package ×1
For frame arms mount: M4×35
For landing gear mount: M3×8,
M2.5×8 (socket cap), M3×22 (socket cap)
CW propellers ×2
CCW propellers ×2
Magic tapes ×4
The red knobs ×6
Landing gear leg rings ×4
Soft dampers ×50
Tools Required
Tools Usage
2.0mm Hex Wrench, 2.5mm Hex Wrench Mounting screws.
Thread Locker Fastening screws.
Nylon Cable Tie
Binding devices and wires.Scissors
Cutting Pliers/Dykes
Foam Double Sided Adhesive Tape Mounting receiver, controller and other modules.
In The Box
To Next Page
Loading...
