©
2017 DJI. All Rights Reserved.
5
Installation
Read the information below before setting up your Zenmuse X4S
Supported Devices
The Zenmuse X4S can be attached to the following device, and will be compatible with other DJI
devices in the future.
DJI Inspire 2
Mounting the Zenmuse X4S to the aircraft
Mounting the Zenmuse X4S to the Inspire 2
Power off the aircraft before installation.
1. Remove the camera body cap from the Zenmuse X4S.
2. Press the gimbal and the camera release button on the Inspire 2. Rotate to remove the
Gimbal Cap from the Inspire 2.
3. Align the white dot on the gimbal with the red dot on the Inspire 2 and insert the gimbal.
4. Rotate the Gimbal Lock to the locked position (red dots aligned).
12
3 4
11
To Next Page
Loading...