Establish connection
To connect the centre and surround speakers remove 2cm of insulation from the
loudspeaker cable. To connect the cable, twist the flex. Then open the loudspeaker clamp ,
stick the bared end of the cable - not insulated parts of the cable - into the opening, and
close the clamp.
You can connect the front speaker boxes using cable with
banana plugs. If you use cable without plugs turn the plastic
screw of the terminal counter clockwise to uncover an
opening within the terminal bolt. Stick the bared end of the
cable - not insulated parts of the cable - (as described
above) into the opening. Then turn the cover clock wise to
lock the terminal.
Please carefully read the instruction manual of the
respective amplifier to learn more about the speaker
connection.
You have paid attention to quality in your purchasing of loudspeakers and you should also
do this when choosing the loudspeaker cable. The cross-section and conductor material
play a decisive role in the later musical pleasure.
6
To Next Page
Loading...
