HCC602 man. v.210520 | 9
LOADING YOUR CARGO
WARNING
Maximum weight of cargo is not to exceed 500 lb. / 226.8 kg.
1. Slide cargo across the frame to find the center of gravity, where the cargo will resit without
excessive rocking.
2. The cargo must be bungee-corded or otherwise tied to prevent swaying.
NOTE: Before each use, be sure all the components of the rack are in good working order.
Verify that all hardware is tight and secure before placing anything on the HCC602.
FOLDING THE FRAME BODY WHEN NOT IN USE
1. Pull out the R-Spring Cotter Pin (5) and then the Connecting Pin (6).
2. Lift the rear edge of the frame body assembly up until the frame body is vertical as show in
fig. 5.
3. Insert the Connecting Pin (6) through the 2” Body Assembly Tube (2) and the lower hole
(Hole A) in the 2” Foldable Tube (4) and insert the Clip (5) into the Connecting Pin (6) to hold
the frame body assembly perpendicular to the hitch receiver tube and close to the rear of
the vehicle (fig 6.)
USE
HOW TO PROPERLY USE YOUR HITCH MOUNTED CARGO CARRIER
ENGLISH
To Next Page
Loading...
