Need help?Do you have a question about the DLG IM-111 and is the answer not in the manual?
General| Brand | DLG |
|---|---|
| Model | IM-111 |
| Category | Touch Panel |
| Language | English |
Details manual distribution, content changes, rights reserved, specification scope, and quality assurance.
Details electrical parameters including input signal, impedance, accuracy, display, and PV retransmission.
Covers operating temperature, IP protection, power consumption, construction, connections, and dimensions.
Explains the frontal display indicators and the function of each keypad button for navigation and operation.
Details menu navigation, submenu selection, parameter value changes, and keypad locking/unlocking.
Configures input type, units, engineering limits, offset, filter, and burn-out behavior for input signals.
Sets alarm set points, hysteresis, alarm type, operation time (T1), and delay time (T2) for two alarms.
Configures retransmission scale, lower/upper limits, safe value, and calibration settings for the analog output.
Allows defining input and output linearization curves using up to 20 points for custom scaling.
Configures Modbus slave address, baud rate, parity settings, and response delay for network communication.
Lists read-only Modbus registers for status, temperature, and analog output values.
Details read/write Modbus registers for configuration parameters like input type, alarms, and linearization.
Diagram and table showing the function of each pin on the rear connector for power, signals, and communication.
Illustrates how to connect current, voltage, thermocouple, frequency, Pt100, and logic input signals.
Covers AC/DC power supply connections, relay outputs, and auxiliary power supply connections.
Specifies the dimensions required for panel mounting the IM-111 indicator.
Provides recommendations for RS-485 cabling, including cable type, grounding, and maximum length.
To Next Page