| 17
Tech Specs
TRANSMITTER
Dimensions: L2.375" x W0.438" x H1.009" (L60.45mm x W11.13mm x H25.7mm)
Weight: 0.375oz
Antenna: Built-in
Power requirement: iPod connection
Modulation: FM Stereo
Frequencies: 88.1-107.9MHz
Frequency response: 50Hz to 18KHz
Operating range: up to 27ft
FCC compliant: (FCC ID # : UIX0702B)
RF REMOTE
Operating Range: Up to 25ft
Transmission Method: Radio Frequency
Frequency: 433.92 MHz
Remote Battery: Panasonic CR2025 3V
Remote Dimensions: L2.297” x W1.1” x H0.205” (L58.33mm x W27.95mm x 5.21mm)
Remote weight: 0.25oz
FCC compliant: (FCC ID # : UIX0703B)
16 | DLO TUNESTIK USER MANUAL
My TuneStik Control keeps reverting to the main playback controls, and
I can’t find my desired frequency.
Remember, when in Frequency Mode, your TuneStik Control will revert back to its
Primary Mode after 10 seconds of inactivity. At that time, the station you were
tuned to will become a new preset on your TuneStik. However, your TuneStik
Control will allow you to tune the TuneStik FM Transmitter before reverting back to
Primary Mode as long as there has not been more than 10 seconds of inactivity (i.e.
pressing a button on the remote).
My radio will only scan to occupied FM stations.
Many car radios default to scan mode for tuning, so they automatically tune to a
radio station. Most of these radios can be switched to manual tuning (consult your
car or stereo manual on how to do this). You can also “find” your TuneStik’s fre-
quency by scanning to it. Most likely, your car stereo’s scan function will automati-
cally find the TuneStik.
TuneStik_manual_GM3_070703:Layout 1 7/3/07 6:18 PM Page 16
To Next Page
Loading...
Need help?
General