| 17
Tech Specs
TRANSMITTER
Dimensions: L2.375" x W0.438" x H1.009" (L60.45mm x W11.13mm x H25.7mm)
Weight: 0.375oz
Antenna: Built-in
Power requirement: iPod connection
Modulation: FM Stereo
Frequencies: 88.1-107.9MHz
Frequency response: 50Hz to 18KHz
Operating range: up to 27ft
FCC compliant: (FCC ID # : UIX0702B)
RF REMOTE
Operating Range: Up to 25ft
Transmission Method: Radio Frequency
Frequency: 433.92 MHz
Remote Battery: Panasonic CR2025 3V
Remote Dimensions: L2.297” x W1.1” x H0.205” (L58.33mm x W27.95mm x 5.21mm)
Remote weight: 0.25oz
FCC compliant: (FCC ID # : UIX0709A)
16 | DLO TUNESTIK USER MANUAL
My TuneStik remote control keeps reverting to the main playback controls, and
I can’t find my desired frequency.
Remember, when in Frequency Mode, your TuneStik remote control will revert
back to its Primary Mode after a few seconds of inactivity. At that time, the station
you were tuned to will become a new preset on your TuneStik. However, your
TuneStik remote will allow you to tune the TuneStik FM transmitter before revert-
ing back to Primary Mode as long as there has not been more than a few seconds
of inactivity (i.e. pressing a button on the remote).
My radio will only scan/seek to occupied FM stations.
Many car radios default to scan/seek mode for tuning, so they automatically tune
to a radio station. Most of these radios can be switched to manual tuning (consult
your car or stereo manual on how to do this). You can also “find” your TuneStik’s
frequency by scanning to it. Most likely, your car stereo’s scan/seek function will
automatically find the TuneStik.
TuneStik_2_manual_GM2_071016:Layout 1 10/16/07 3:17 PM Page 16
To Next Page
Loading...
Need help?
General