INSTRUCTIONS USE:
1. To ensure a correct helmet position, it must be the right size
of your head and it has to t perfectly. The fastening system
must always be adjusted and fastened correctly.
2. The helmet is designed to absorb shock by partial destruction
of the shell and liner. This damage may not be visible.
Therefore, if subjected to a severe blow, the helmet should be
replaced even if it is apparently undamaged.
3. The visor has to be always clean and without scratches. Do
not t the colored visor when it is night or with a low visibility.
For your safety remember to replace the visor when it is
deteriorated.
4. Never transport your helmet attached to the bike. Always
keep it away from the exhaust pipe and from heat sources.
5. Clean inside and outside the helmets only with water and
neutral soap. Never use solvents, petrol, or other chemicals.
To clean the helmet, you must use only:
- For the shell: water and mild soap
- For the comfort padding: warm water and mild soap
- For the visor: water and soap, taking care not to scratch it.
- Leave the helmet to dry at ambient temperature. Do not
expose it to heat sources.
- The liner is essential to the intended performance of the
helmet.
6. We suggest to not use a helmet for more than 5 years.
7. Verify that on the helmet there is the homologation tag.
To Next Page
Loading...